Click here to make tpub.com your Home Page

Page Title: CLEANING AND INSPECTION
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 5-2410-237-23
TIMING GEARS, BEARINGS, AND TIMING GEAR PLATE REPLACEMENT - CONTINUED
0245 07
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to follow this
warning may cause injury or death.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Failure to
follow this warning may result in injury. Make sure air stream is directed away from user and other
personnel in the area. To prevent injury, user must wear protective goggles or face shield.
NOTE
Keep all related components together. Do not mix components.
1.
Clean all disassembled and cast components with cleaning compound:
a.
Place all disassembled components in wire baskets for cleaning.
b.
Dry and cover all cleaned components.
c.
Place components on or in "racks" and hold for inspection or repair.
d.
Lightly oil and wrap all components subject to rusting.
e.
Clean inner and outer surfaces of castings and all areas subject to grease and oil with cleaning solvents.
f.
Use a stiff brush to remove sludge and gum deposits.
g.
Blowout all tapped (threaded) holes with compressed air to remove dirt and cleaning fluids.
h.
Dry machined surfaces with compressed air.
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic mate-
rial. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-venti-
lated areas. Keep away from open flames and other sources of ignition. Failure to follow this warning may
cause injury or death.
2.
Pay particular attention to all oil passages in castings and machined components. Oil passages must be clean and free of
any obstructions:
a.
Clean oil passages with wire probes to break up any sludge or gum deposits.
b.
Wash oil passages by flushing with cleaning compound.
c.
Dry oil passages with compressed air.
3.
Inspect components for wear and cracks. Inspect castings for cracks using a magnifying glass and a strong light. Inspect
machined surfaces for nicks, burrs, or raised metal. Replace or repair as necessary.
0245 07-3
Change 1

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business