 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
RIPPER ASSEMBLY MAINTENANCE - CONTINUED
0238 00
REMOVAL - CONTINUED
14.
Install a bar through front pin holes (16) of beam (1).
15.
Attach a suitable lifting device on bar between two points (17) on beam (1).
16.
Remove two bolts (18) and plate (19) from pin assembly (20) securing frame assembly (2) to beam (1).
17.
Repeat step 16 to remove pin assembly (20) on other side of frame assembly (2) and beam (1).
18.
Remove grease fitting (21) from end of each pin assembly (20), if required.
NOTE
Put slack in slings before attaching chains.
19.
Install a bar through bore (22) and, with a suitable three-point lifting device, remove beam (1) from frame assembly (2).
20.
Attach a suitable lifting device to frame assembly (2) and lift frame so it is level with tractor. Place blocks underneath
frame assembly.
NOTE
Prior to removal, tag lift cylinders as left and right to identify for assembly.
21.
With a nylon sling and a suitable lifting device attached, release lift cylinder (6) from mounting bracket (15). Remove
two bolts (23), plate (24) and spacers (25) from each side of frame assembly (2).
22.
Remove pin assembly (26) from frame assembly (2) that attaches lift cylinder (6) to mounting bracket (15).
23.
Remove grease fitting (27) from pin assembly (26), if required.
24.
Remove lift cylinder (6) from frame assembly (2).
25.
Repeat steps 21-24 for other lift cylinder (6).
16
17
1
22
6
16
15
20
21
26
2
25 24
23
387-764
27
18 19
0238 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals