 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
BLADE AND PUSHARM ASSEMBLY REPLACEMENT - CONTINUED
0235 00
INSTALLATION - CONTINUED
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,238
kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground
and shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic
tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic
fluid under pressure can penetrate the skin, causing serious injury or death.
5.
Relieve hydraulic system pressure (WP 0241 00).
6.
Remove four nuts (24), eight washers (20), four capscrews (19), split flanges (21 and 22) and plate (23) to disconnect
hose (9) from (10). Repeat to remove hose (17) from (18).
7.
Connect hose (10), plate (23) and hose (18). Secure
7
8
9
with split flanges (21 and 22), four capscrews (19),
eight washers (20) and nuts (24). Repeat to connect
10
hose (9), plate (23) and hose (17).
8.
Place clamp (16) around hoses (17 and 18). Place
hoses and clamp in position on radiator guard and
install two washers (14), capscrews (13) and nuts (15).
9.
Place clamp (12) around tilt cylinder hoses (9 and 10)
and install capscrew (11) and clamp to radiator guard.
10.
Place clamp (8) around tilt cylinder hoses (9 and 10)
and install capscrew (7) and clamp to radiator guard.
12
11
24,20
21
19,20
23
22
17
18
13,14,15
16
387-775
0235 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals