 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
RIPPER LIFT CYLINDER REPAIR - CONTINUED
0224 00
DISASSEMBLY
NOTE
Prior to disassembly of lift cylinder, inspect external casing of lift cylinder for serviceability (cracks and
damage). If not serviceable, replace lift cylinder.
1.
Scribe a mark on head (1) and cylinder housing (2) for correct alignment at assembly.
2.
Remove eight bolts (3) and washers (4) holding two plates (5) to bosses (6) on cylinder housing (2).
3.
Remove six bolts (7), washers (8), two tube assemblies (9) and O-rings (10) from head (1) and cylinder housing (2).
Discard O-rings.
7
8
9
10
6
9
7
8
10
4
1
4
2
387-729
5
4
3
4.
Remove four bolts (11) and washers (12) from head (1).
5.
Pull piston rod (13) and piston assembly slowly from cylinder housing (2) to allow oil to escape.
6.
If required, remove two grease fittings (14) from cylinder housing (2) and piston rod (13).
7.
Inspect four bearing sleeves (15) for serviceability. Replace lift cylinder if not serviceable.
CAUTION
Protect piston rod and use care when placing in vise.
8.
Place piston rod (13) in vise and remove self-locking nut (16) from piston rod. Discard self-locking nut.
9.
Remove piston (17) from piston rod (13).
0224 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals