BLADE LIFT CYLINDER REPLACEMENT - TM-5-2410-237-231125

TM 5-2410-237-23

BLADE LIFT CYLINDER REPLACEMENT

0220 00

THIS WORK PACKAGE COVERS

Removal, Installation, Adjustment

INITIAL SETUP

Materials/Parts - Continued

Tools and Special Tools

Lockwasher (9)

Tool kit, general mechanic's (Item 122, WP 0250

O-ring (4)

Shop equipment, common no. 1 (Item 103, WP

References

0250 00)

Sling, nylon (Item 109, WP 0250 00)

Personnel Required

Lifting equipment, 1,000 lb capacity

Three

Materials/Parts

Equipment Condition

Cap set, protective (Item 2, WP 0249 00)

Machine parked on level ground (TM 5-2410-237-

Grease, GAA (Item 16, WP 0249 00)

10)

Oil, lubricating (Item 23, 24 or 25, WP 0249 00)

Hydraulic system cool (TM 5-2410-237-10)

Hydraulic system pressure relieved (WP 0241 00)

Rag, wiping (Item 29, WP 0249 00)

WARNING

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting

unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,237

kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground

and shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic

tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic

fluid under pressure can penetrate the skin, causing serious injury or death.

REMOVAL

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal. Cap lines and plug open-

ings after removing lines. Contamination of hydraulic system could result in premature failure.