 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
HYDRAULIC FILTER ASSEMBLY AND FILLER STRAINER REPLACEMENT - CONTINUED
0218 00
FILTER ASSEMBLY CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic mate-
rial. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-venti-
lated areas. Keep away from open flames and other sources of ignition.
1.
Use solvent cleaning compound to clean filter assembly components.
2.
Inspect components for damage. Replace any damaged component.
FILTER ASSEMBLY INSTALLATION
NOTE
Lightly coat new O-rings with clean oil before installation.
1.
Install spacer (9) and new O-ring (8) on bolt (1).
2.
Install new O-ring (7) on cover (6).
3.
Install cover (6) on bolt (1).
4.
Slide new filter element (5) over bolt (1) to mate with cover (6).
5.
Install screen assembly (4) on bolt (1).
6.
Install nut (3) on bolt (1).
7.
Install filter assembly in hydraulic tank (2) and tighten bolt (1).
8.
Check oil level in sight gage (10) on hydraulic tank (2). Add oil as needed until level is visible in sight gage. Refer to
PMCS Introduction (WP 0009 00) to determine grade of oil to be used IAW expected temperature range of operation.
9.
If loose, tighten filler cap (11) on hydraulic tank (2).
0218 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals