 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
HYDRAULIC PUMP REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
Tag, marker (Item 37, WP 0249 00)
Tool kit, general mechanic's (Item 122, WP 0250
O-ring (6, 12 and 18)
Shop equipment, common no. 1 (Item 103, WP
References
TM 5-2410-237-10
Sling, nylon (Item 109, WP 0250 0)
Personnel Required
Lifting equipment, 100 lb capacity
Two
Materials/Parts
Equipment Condition
Cap set, protective (Item 2, WP 0249 00)
Hydraulic system pressure relieved (WP 0241 00)
Oil, lubricating (Item 23, 24 or 25, WP0249 00)
Hydraulic tank drained (WP 0225 00)
Floor plates removed (WP 0171 00)
Rag, wiping (Item 29, WP 0249 00)
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,237
kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground
and shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic
tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic
fluid under pressure can penetrate the skin, causing serious injury or death.
REMOVAL
CAUTION
Wipe area clean around all hydraulic connections to be opened during removal. Cap oil lines and plug
openings after removing lines. Contamination of hydraulic system could result in premature failure.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals