Click here to make tpub.com your Home Page

Page Title: CHANGING OIL FILTER ELEMENT
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 5-2410-237-23
WINCH OIL FILTER ASSEMBLY MAINTENANCE - CONTINUED
0185 00
CHANGING OIL FILTER ELEMENT - CONTINUED
1.
Remove plug (1) and seal (2) and let oil drain into a suitable container. Discard seal. Install plug with new seal after oil
has drained.
2.
Remove six capscrews (3), lockwashers (4) and washers (5) from filter cover (6). Discard lockwashers.
3.
Remove filter cover (6) and filter element (7) with packing retainer (8). Discard filter element and packing retainer.
4.
Remove O-ring (9) from filter cover (6). Discard O-
ring.
NOTE
Lightly coat new packing retainer and new O-
8
ring with clean oil before installation.
5.
Put clean oil on new packing retainer (8). Install new
7
filter element (7) and new packing retainer (8).
6
6.
Install new O-ring (9) in groove on filter cover (6).
5
4
7.
Position filter cover (6) and align capscrew holes.
3
8.
Install six capscrews (3), new lockwashers (4) and
washers (5) to filter cover (6).
9.
Start engine and run at low idle. Check level of oil in
winch sight gage. Add oil if oil is not visible in sight
9
1,2
10.
Check winch for proper operation and leaks (TM 5-
387-474
2410-237-10).
OIL FILTER ASSEMBLY REMOVAL
1.
Remove oil filter element. Refer to Changing Oil Fil-
ter Element.
2.
Remove one capscrew (10) and lockwasher (11) near
top of access cover (12). Discard lockwasher. Install a
guide screw in place of capscrew.
3.
Remove remaining 14 capscrews (10) and lockwash-
ers (11) from access cover (12). Discard lockwashers.
4.
Lift access cover (12) and gasket (13) from guide
screw. Discard gasket.
10,11
5.
Remove capscrew (14) and lock (15).
6.
Remove two capscrews (16) and washers (17) from
INSTALL
filter head (18).
GUIDE
7.
Lower filter head (18) and pipe (19) to remove from
SCREW
winch case.
HERE
8.
Separate pipe (19) from filter head (18).
9.
Remove and discard two O-rings (20).
12
387-475
0185 00-2

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business