INSTALLATION - TM-5-2410-237-230885

TM 5-2410-237-23

ROPS MOUNTING BRACKETS AND PLATES REPLACEMENT - CONTINUED

0165 00

INSTALLATION

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to

personnel.

NOTE

If ROPS is replaced, new ROPS will not come with welded on angle brackets to mount protective

screen. Perform this task to weld angle brackets on new ROPS.

Support assembly weighs 453 lb (206 kg).

Apply antiseize compound to all mounting capscews before installation.

Ensure all mounting bracket and plate mounting hardware is tightened IAW torque limits (WP 0245

Use a nylon sling and a suitable lifting device to position support assembly (24) at rear of machine.

Install capscrew (28), washer (29) and shims (30) on one side of support assembly (24). Do NOT tighten capscrew.

Install three capscrews (25), six washers (26) and three nuts (27) on same side of support assembly (24). Do NOT

tighten capscrews.

Repeat steps 2 and 3 on other side of support assembly

(24).

21,22 23

17,18,19 20

Tighten all capscrews (25 and 28). Remove nylon

sling lifting device.

Install gas can support bracket (23) on support assem-

bly (24) with four capscrews (21) and washers (22).

387-280

28,29,30

25,26,27

NOTE

Cover weighs 17 lb (8 kg).

Install cover (20) on support assembly (24) with five capscrews (17), washers (18) and new lockwashers (19).

Install block (16) at left rear of machine with three capscrews (14) and washers (15).

0165 00-3