 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
STEERING BRAKE HYDRAULIC CONTROL ASSEMBLY MAINTENANCE - CONTINUED
0151 00
ASSEMBLY - CONTINUED
NOTE
Install two shaft bearings with identification lettering facing center of hydraulic control, so that lettering
can be seen after installation.
11.
Install two bearings (95) in brake control shaft hole on inside of hydraulic control (12). Lettered edge of bearings must
be installed until they are 0.031 in. (0.79 mm) below edge of hole in hydraulic control.
12.
Install sleeve (86) in counterbore inside hydraulic control (12). Sleeve must bottom in counterbore.
13.
Insert spring (85) in piston (84) and install piston in counterbore and make contact with sleeve (86).
14.
Install valve spring (83) and valve (82) in plunger (77) and secure with retaining ring (81).
15.
Install retainer (76) on other end of plunger (77) and secure with retaining ring (80).
16.
Install inner spring (79) and outer spring (78) over plunger (77) and seat on retainer (76).
17.
Install plunger assembly (65) with plunger (77) through sleeve (86), and inner spring (79) and outer spring (78) over
sleeve (86).
18.
Use a large screwdriver to apply pressure to retainer (76) to compress springs. Insert a capscrew between retainer and
inside of hydraulic control (12).
95
95
95
12
84
12
65
86
0.031 IN.
(0.79 MM)
85
81 82 83
65
77
79
78
76 80
387-721
WARNING
Do not disturb capscrew holding plunger assembly until lever (66) and cover (57) assemblies are in place.
Spring pressure behind plunger assembly could cause injury or lost parts.
19.
Install roller (75) in lever (66) with pin (74) and new cotter pin (73).
20.
Force lever (66) open for assembly.
21.
Insert shaft (64) through seal (94), bearing (95), one side of hydraulic control (12), lever (66) and into other side of
hydraulic control.
22.
Insert key (72) in shaft (64). Align key with slot in lever (66) and slide lever onto key as far as possible.
23.
Drive shaft (64) to center lever (66) on key (72) and center shaft in hydraulic control (12). Remove tool from lever.
0151 00-12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals