 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRACK DRIVE SPROCKET/HUB REPLACEMENT - CONTINUED
0141 00
INSTALLATION - CONTINUED
14.
Install new retainer lock (28) and nut (29).
15.
Bend one tab of retainer lock (28) in notch of nut (29)
and one tab in notch of sprocket (27) hub.
28
29
30
WARNING
Use insulated gloves for handling hot
parts to avoid personal injury.
Heat bearing (30) to 275F (135C) maximum. Install
16.
bearing on final drive hub against nut (29).
27
387-663
17.
Lower temperature of bearing (30) and install bearing cup (24) in cage (23).
18.
Align slot in cage (23) over dowel in holder (17) and install cage in holder.
19.
Install new gasket (22) in groove in holder (17).
20.
Apply clean grease to threads of adjusting nut (18) and on face of nut that contacts gasket (22) in holder (17).
21.
Install adjusting nut (18) on holder (17) and tighten completely to end of thread travel.
CAUTION
New seal assemblies and new preformed packings must be used as matched pairs or failure will result.
Do not separate.
Seal and seal contact surfaces must be kept clean. Do not touch after being cleaned or leaks can result.
NOTE
Do not apply oil to preformed packings.
22.
Install new seal assemblies (20) and new preformed packing (21) inside adjusting nut (18). Clean metal contact surface
of seal assembly, then apply a thin film of clean oil to metal contact surface.
23.
Install new seal assembly (25) and new preformed packing (26) in hub of sprocket (27). Clean metal contact surface of
seal assembly, then apply a thin film of clean oil to metal contact surface.
24.
Install woodruff key (19) in sprocket shaft (8).
19 (HIDDEN)
26
21
21
20
18
24
23
22
17
27
387-936
0141 00-10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals