 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRACK ADJUSTER CYLINDER MAINTENANCE - CONTINUED
0140 00
REMOVAL - CONTINUED
3.
Remove capscrew (5) and washer (6) from shaft of recoil spring and tighten nut (7) against rear pilot of recoil spring
until pressure against front stops (8) is released.
4.
Remove hydraulic track adjuster from front pilot of recoil spring.
5.
Remove seal (9) from front pilot of recoil spring. Discard seal.
8
9 (HIDDEN)
7
6
5
387-353
6.
Remove seal (10) and ring (11) from cylinder (12).
17
14
16
19 18
15
Discard seal.
13
19
7.
Remove piston (13) assembly from cylinder (12).
16
8.
Remove fill valve (14), relief valve (15) and two
washers (16) from cylinder (12). Discard washers.
9.
Remove ring (17) and seal (18) from piston (13). Dis-
card seal.
10.
Remove two rings (19) from piston (13).
INSTALLATION
10 11
387-354
1.
Install fill valve (14) and washer (16) in cylinder (12).
12
Install relief valve (15) and washer (16) in cylinder.
Tighten both valves to 25 lb-ft (34 Nm).
2.
Install two rings (19) on piston (13). Install new seal (18) on piston with sealing lip toward ring (17) that holds seal in
position. Install ring to secure seal.
3.
Install piston (13) assembly in cylinder (12).
NOTE
Lubricate new seal with a thin coating of clean oil prior to installation.
4.
Install new seal (10) in cylinder (12). Install ring (11) next to seal with chamfer toward cylinder.
5.
Install new seal (9) in front pilot of recoil spring. Put grease on seal.
6.
Install hydraulic track adjuster assembly in position in front pilot of recoil spring.
0140 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals