 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
EQUALIZER BAR ASSEMBLY REPLACEMENT - CONTINUED
0133 00
INSTALLATION - CONTINUED
1.
Install right support assembly (8) as follows:
a. Install lower suspension (13).
b. Install pad (12).
c. Install lower plate (11).
d. Install upper plate (10).
2.
If removed, repeat step 1, a through d, for left support assembly (8).
3.
Install left support (9) with four new lockwashers (7) and bolts (6). Tighten bolts to 350 lb-ft (475 Nm).
4.
Use a suitable lifting device to place equalizer bar (5) on hydraulic floor jack.
5.
Push floor jack with equalizer bar (5) between tracks at rear of tractor. Rotate bar to align one end with left support
assembly (8).
6.
Move floor jack forward to position other end of equalizer bar in line with right upper plate (10).
7.
Install right support (9) over end of equalizer bar (5) and on track roller frame.
NOTE
Make sure equalizer bar is centered on upper plate assembly.
8.
Lower hydraulic jack until weight of equalizer bar is on right upper plate assembly (10).
9.
Install four new lockwashers (7) and bolts (6) on right
support (9). Tighten capscrews to 350 lb-ft (475 Nm).
10.
Install two pads (4), plates (3), four new lockwashers
(2) and bolts (1) on equalizer bar (5).
5
11.
Tighten bolts (1) to 350 lb-ft (475 Nm).
12.
Lower tractor to ground (WP 0243 00).
13.
Install crankcase and transmission guards (WP 0157
14.
Install track roller frame guards (WP 0163 00).
3
2
15.
Install right-front carrier roller. If removed, install left-
4
front carrier roller (WP 0137 00).
1
387-477
16.
Operate tractor and check for proper operation (TM 5-
2410-237-10).
END OF WORK PACKAGE
0133 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals