 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRANSMISSION CONTROL VALVES REPLACEMENT - CONTINUED
0117 00
INSTALLATION - CONTINUED
15.
Check and adjust relief valve setting. Refer to Relief Valve Setting Adjustment below.
16.
Install seat and seat base assembly (WP 0172 00).
17.
Install floor plates (WP 0171 00).
RELIEF VALVE SETTING ADJUSTMENT
1.
Perform direction clutch test (primary setting) (WP 0122 00).
a.
Each 0.035 in. (0.90 mm) spacer will change setting by 10.9 psi (75 kPa).
b.
Each 0.010 in. (0.25 mm) spacer will change setting by 2.9 psi (20 kPa).
CAUTION
Wipe valve body clean prior to disassembly. Perform disassembly in a clean work environment. Contami-
nation of transmission could result in premature failure.
NOTE
Disassembly of pressure control valve is authorized to add or remove spacers in order to adjust relief valve
setting.
2.
Add or remove spacers in pressure control valve if
38
required to adjust relief valve setting:
39
35
39
a.
Remove four capscrews (35) and cover (36) from
39
pressure control valve body (37).
47
57
NOTE
36
56
Note quantity and size of spacers.
b.
Remove piston (38) and spacers (39) from valve
body (37).
c.
Remove and discard two O-rings (40).
48
56
d.
Add or remove spacers (39) to achieve correct
relief valve setting.
37
387-627
NOTE
Lightly coat new O-rings with clean oil
before installation.
e.
Install piston (38) and two new O-rings (40).
f.
Install cover (36) with four capscrews (35).
3.
Operate machine and check transmission for proper operation (TM 5-2410-237-10).
END OF WORK PACKAGE
0117 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals