 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRANSMISSION OIL COOLER LINES REPLACEMENT - CONTINUED
0108 00
INSTALLATION
CAUTION
Wipe clean all components, lines and fittings as connections are made to prevent contamination from enter-
ing transmission.
NOTE
Lightly coat new O-rings with clean oil before installation.
1.
If diverter manifold (23) was removed, position new O-ring (32) on transmission manifold. Place diverter manifold in
position and secure with two new lockwashers (31) and bolts (30).
2.
Position new O-ring (29) and hose assembly (28). Install two new lockwashers (27) and capscrews (26). Do NOT fully
tighten capscrews.
3.
Position new O-ring (25), hose assembly (28) and two flange halves (22) on diverter manifold (23). Secure with four
capscrews (20) and washers (21).
4.
Position new O-ring (24) and hose assembly (14) in position on diverter manifold (23). Secure with four capscrews (20)
and washers (21) and tighten.
5.
Position new O-ring (19) and tube assembly (15) on oil cooler outlet. Secure with two capscrews (16) and new lock-
washers (17).
6.
Position new O-ring (18), hose assembly (14) and flange halves (13) to tube assembly (15). Secure with four capscrews
(11) and washers (12).
7.
Position new O-ring (10) and tube assembly (6) at oil cooler inlet. Secure with two capscrews (7) and new lockwashers
(8).
8.
Position clamp set (4) around tube assemblies (6 and 15) and secure loosely with capscrew (1), new lockwasher (2) and
nut (3).
9.
Position new O-ring (9) and tube assembly (6) at torque converter outlet relief valve. Secure with four capscrews (5).
10.
Fully tighten capscrew (1) and nut (3).
11.
Refill transmission oil (WP 0107 00).
12.
Run engine and check for proper operation and leaks.
13.
Install floor plates (WP 0171 00).
14.
Install seat with vertical adjuster (WP 0174 00).
END OF WORK PACKAGE
0108 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals