 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
FLYWHEEL HOUSING MAINTENANCE - CONTINUED
0031 00
ASSEMBLY
17 19
18
15 14
12 16
1.
If removed, install dowels (20 and 21) and stud (22)
into housing (6). Tighten studs to 40 lb-ft (54 Nm).
2.
Use a suitable driving tool to install two bearings (19).
20
3.
Install two washers (17) and pins (18).
4.
Install cover (15) and new gasket (16) with four cap-
13
screws (14).
21
5.
Install plug (13).
6.
Install plug (12).
7.
Position two brackets (11) on flywheel housing (6)
22
11
and install four washers (10) and capscrews (9).
10
8.
Install rear accessory drive gears (WP 0037 00).
9
8
6
387-317
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Flywheel housing weighs approximately 350 lb (159 kg).
1.
Fasten lifting equipment to flywheel housing (6).
NOTE
Ensure all mounting surfaces are clean and dry.
2.
Install new gasket (8) on flywheel housing (6).
3.
Use lifting equipment to place flywheel housing (6) in position against cylinder block.
0031 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals