Click here to make tpub.com your Home Page

Page Title: INSTALLATION
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 5-2410-237-23
FRONT ENGINE SUPPORT REPLACEMENT - CONTINUED
0022 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
1.
Install engine front support (4) in position on trunnion (10).
2.
Install capscrews (8) and washers (9). Tighten capscrews to 75 lb-ft (102 Nm).
3.
Lift engine slightly, remove jack stands and wood cribbing from under oil pan and flywheel housing.
NOTE
Before setting front of engine on frame, ensure front support and frame holes are aligned.
4.
Lower front of engine until engine front support (4) is resting on frame.
5.
Install two capscrews (7), washers (6) and nuts (5) on engine front support (4). Tighten capscrews to 150 lb-ft (203 Nm).
6.
Tighten two capscrews (1) and washers (2) that attach engine rear supports (3) at each side of flywheel housing. Tighten
capscrews to 150 lb-ft (203 Nm).
7.
Lower fully and remove lifting device from engine.
8.
Install vibration damper (WP 0029 00)
9.
Crankshaft pulley (WP 0028 00).
10.
If removed, install crankcase guard (WP 0157 00).
11.
Run engine and check for proper operation and leaks (TM 5-2410-237-10).
END OF WORK PACKAGE
0022 00-3

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business