Inspection and Repair. - TM-5-2410-233-340151

50 Shaft assembly

Key to figure 5-20.

51 Guide

1 Bolt

52 Key

2 Washer

5 3 Pin

3 Gasket

54 Gasket

4 Bolt

5 5 Plug

5 Washer

56 Washer

6 Cover

57 Plunger

7 Gasket

58 Spring

8 Bolt

5 9 Plug

9 Cover

60 Spacer

10 Gasket

61 Packing

1 1 Nut

62 Piston and valve assembly

12 Washer

6 3 Bolt

13 Bolt

64 Locking plate

14 Clamp

6 5 Ring

15 Capscrew

66 Cylinder

16 Lock washer

67 Weight assembly

1 7 Ring

6 8 Ring

18 Seal

69 Bearing race

19 Plate assembly

70 Bearing

20 Spring

71 Seat

21 Pin

72 Spring

22 Roller

73 Washer

23 Spring

7 4 Pin

2 4 Bolt

7 5 Pin

25 Cover

76 Seat

26 Gasket

7 7 Ring

27 Screw assembly

78 Washer

2 8 Pin

79 Spring

29 Screw

80 Plunger

30 Spring

81 Pin

31 Spacer

82 Spring

32 Screw

83 Plunger

33 Packing

8 4 Bolt

34 Screw

85 Lockplate

35 Packing

86 Lever assembly

3 0 Bolt

87 Band assembly

37 Nut

88 Housing assembly

38 Setscrew

8 9 Bolt

39 Collar

90 Locking plate

40 Collar

91 Spacer

41 Spring

92 Retainer

42 Nut

93 Spacer

43 Lockwasher

94 Spacer

44 Washer

95 Contact

45 Insulator

96 Spring

46 Screw

97 Bar

47 Washer

48 Insulator

49 Shaft assembly

e. Reassembly (fig. 5-20).

c. Cleaning. Clean all components with cleaning

(1) If the guide was removed, press a new

solvent (Fed. Spec. P-D-680) and dry with com-

guide into position in the housing (88). Form the

pressed air.

guide against the chamfer in the governor housing.

d. Inspection and Repair.

Install the band assembly (87).

(1) Inspect the housing and cover for breaks,

(2) Install the spring (82), plunger (83) and

cracks and rough mating surfaces. Repair by

pin (81) to the lever (86). Install the lever assembly

welding.

in the housing and secure with the lock plate (85)

(2) Inspect control levers for cracks, breaks

and bolt (84).

and worn bores. Inspect pins for wear and damage.

(3) Install the governor control shaft (49) and

Replace worn parts.

(3) Inspect springs for cracks and other

seal (18).

(4) Install the low idle stop plunger (57),

dam age. Replace weak or damaged springs.

spring (58), washer (56) and plug (55). Install the

(4) Inspect rollers and bushings for wear.

Replace bushings if worn or loose. Replace rollers if

plug (59).

worn or out-of-round.

(5) Install a new gasket (26). Install the low

5-27