 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
BLADE LIFT CYLINDER REPLACEMENT - CONTINUED
0157 00
REMOVAL - CONTINUED
7.
Remove four bolts (15), lockwashers (16), two end
18
17
15,16
caps (17) and lift cylinder (6) from mounting tube
yoke (18). Discard lockwashers.
8.
Inspect two bearings from pivots on lift cylinder (6).
386-806
6
INSTALLATION
NOTE
Before installation of bearings, lubricate bearing with clean GAA grease.
Ensure mating surfaces for bearings are clean and not damaged.
1.
If removed, install two bearings on pivots of lift cylinder (6).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Lift cylinder weighs 242 lb (110 kg).
2.
Attach a nylon sling and a suitable lifting device to upper part of lift cylinder (6) and position lift cylinder pivots at
mounting yoke (18).
3.
Install two end caps (17) to lift cylinder mounting tube yoke (18) with four new lockwashers (15) and bolts (16).
0157 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals