 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
BLADE TILT ADJUSTABLE BRACE REPLACEMENT - CONTINUED
0156 00
INSTALLATION AND ADJUSTMENT
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Blade tilt adjustable brace weighs approximately 60 lb (27 kg).
1.
Use a nylon sling and a suitable lifting device to position brace (1) at pusharm (7). Secure rod (4) to pusharm with pin
(6) and new cotter pin (5).
2.
Lengthen brace (1) as needed and adjust sling and lifting device.
3.
Install ball joint sockets (12 and 10) to bulldozer blade (3) with four bolts (8). DO NOT install lockwashers (9) or shims
(11). Tighten bolts evenly.
4.
Measure gap between two ball joint sockets (10 and 12) without shims (11).
5.
Remove four bolts (8) and shorten brace (1). Install shims (11) equal in thickness to measure gap, plus add ONE shim.
6.
Lenghten brace (1) and install four new lockwashers (9) and bolts (8).
7.
Apply GAA grease to grease fittings at ball joint sockets (10 and 12) and to grease fitting at brace screw threads.
8.
Check bulldozer blade for proper operation (TM 5-2410-233-10).
END OF WORK PACKAGE
0156 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals