 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
RIPPER CONTROL LEVER AND LINKAGE REPLACEMENT- CONTINUED
0152 00
INSTALLATION - CONTINUED
3.
Perform Adjustment below.
4.
Install floor plates (WP 0135 00).
5.
Check for proper operation of ripper controls (TM 5-2410-233-10).
ADJUSTMENT
NOTE
Adjustment of ripper control linkage is required when the following conditions occur:
Ripper raises or lowers without operator moving control lever.
Ripper does not have full travel up or down.
Ripper control lever and linkage have been removed, replaced or repaired.
1.
Adjust ripper control lever linkage by loosening jam nut (6) at each end of rod (7).
2.
Turn rod (7) until ripper control lever assembly (5) is in center of travel position.
3.
Tighten jam nuts (6) while holding rod (7).
6 (HIDDEN)
7
6
5
386-774
END OF WORK PACKAGE
0153 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals