TRACK DRIVE SPROCKETS/HUBS REPLACEMENT - CONTINUED
INSTALLATION - CONTINUED
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
Sprocket weighs 400 lb (181 kg).
Use a nylon sling and a suitable lifting device to lift
sprocket (27) into position at end of drive hub. Align
splines carefully and push sprocket onto drive hub as
far as possible by hand.
Install adapter (31) on drive hub and turn adapter until
it is fully on drive hub.
Install stud (34) in adapter (31).