 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRACK ROLLER FRAME ASSEMBLY REPLACEMENT - CONTINUED
0110 00
ALIGNMENT - CONTINUED
10
A
22
23
21
24
20
18
19
B
386-223
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
4.
Raise machine (WP 0178 00) until both tracks are off ground.
5.
Release tension from tracks (WP 0119 00).
NOTE
Refer to WP 0118 00 for assistance in performing steps 6-9.
6.
Remove holder assembly (19).
7.
Remove cap (20), lock (21), nut (22), retainer assembly (23) and shims (24).
NOTE
Thickness of one shim is 0.036 in. (0.91 mm). Use the least amount of shims and do NOT use more than
seven shims on either side of machine.
8.
Change alignment of rear track carrier roller (10) to sprocket (18) by installing or removing shim(s) (24) from final drive
support.
a.
Install shim(s) (24) between retainer assembly (23) and holder (19) of final drive to move track roller frame out to
make distance A more.
b. Remove shim(s) (24) between retainer assembly (23) and holder (19) of final drive to move track roller frame in to
make distance A less.
9.
Install retainer assembly (23), nut (22), lock (21), and cap (20).
10.
Lower machine to ground and remove lifting device (WP 0178 00).
11.
Adjust track (WP 0120 00).
12.
Run machine and check track for proper operation (TM 5-2410-233-10).
END OF WORK PACKAGE
0110 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals