REMOVAL - CONTINUED - TM-5-2410-233-230300

TM 5-2410-233-23

GOVERNOR CONTROLS AND LINKAGE MAINTENANCE - CONTINUED

0054 00

REMOVAL - CONTINUED

15.

Loosen jam nuts (49 and 50) at each end of rod (51).

16.

Remove nut (52), lockwasher (53) and ball joint (54) from bellcrank (34). Remove upper end of rod (51). Discard

lockwasher.

17.

Remove cotter pin (55), washer (56) and pin (57) from clevis (58). Remove lower end of rod (51) from governor control

link (59). Discard cotter pin

18.

Remove spring (60) from lower end of governor control link (59) and from plate (61).

19.

Remove cotter pin (62), washer (63), plate (61), washer (64) and rod end connector (65) from lever (66). Discard cotter

pin.

NOTE

If lever or component inside of a lever requires removal, drive small chisel into slot in lever to open it up for

removal.

20.

If lever (66) requires removal, remove nut (67), capscrew (68), lever and key (69) from support (70)

21.

Loosen jam nut (71) and remove cotter pin (72), washer (73) and pin (74) from clevis (75). Remove lower end of

governor control link (59). Discard cotter pin.

22.

If governor control lever (76) requires removal, remove nut (77), capscrew (78) and governor control lever from

governor.

0054 00-4