Figure 4-27. Spring anchor adjustment.

Figure 4-27. Spring anchor adjustment.

screw and raise or lower contact point bracket until

(2) Voltage regulator. The voltage regulator

a gap of 0.048 to 0.052 inch is obtained. Tighten

requires two checks and adjustments as follows:

bracket adjustment screw securely after making

(a) Air gap. W i t h b a t t e r y d i s c o n n e c t e d ,

adjustment. When armature is held down so that

check air gap (fig. 4-28). Insert gage on contact

stop rivet rests on magnet core, point gap should be

point side of air gap next to armature stop rivet. If

a minimum of 0.012 inch.

adjustment is needed, loosen bracket adjustment