NOTES - LO-5-2420-219-120006

LO 5-2420-219-12

*-KEY-

EXPECTED TEMPERATURES

Above +15 F

+ 40 F to -15 F

+40 F to -65 F

LUBRICANTS

CAPACITY

INTERVALS

(Above -9 )

(+ 4 to -26 )

(+4 to -54 )

Air Cleaner

7 qts.

C/MR -

(6.62 L)

Condition

Hydraulic

120 qts.

Monitor

Reservoir

(113 1/2 L)

Transmission

22 qts.

(20.8 L)

Lubricating

GO 80W/90

GO 75W0

Oil, Gear,

Multipurpose

Front

8 qts. ea

Planetary

(7.56 L) ea

Drive

Intervals

Rear

8 qts. ea

Planetary

(7.56 L) ea

given are

Drive

in hours

Front

12 qts.

of normal

Differential

(11.35 L)

Rear

12 qts

operation.

Differential

(11.35 L)

Winch Case

14 qts.

and Drive

(13.24 L)

Housing

GAA -

Grease

Automotive

ALL TEMPERATURES

and Artillery

*See Note 13 for lubricant specification number.

NOTES:

2. OIL CAN POINTS. Each 50 hours, lubricate yoke

pins, ball and socket joints, pivot pins, control linkages

FOR OPERATION OF EQUIPMENT IN

and all exposed adjusting threads with OE/HDO.

PROTRACTED COLD TEMPERATURES BELOW-15F

(-26C).

Remove lubricants prescribed in Key for

3. ENGINE CRANKCASE OIL LEVEL HOT OR COLD

CHECK. Cold engine, oil level should be at high mark

temperatures above -15F (26C).

Relubricate with

on dipstick. Hot engine, oil level must be between high

lubricants specified in Key for temperatures below -15F

and low marks on dipstick (allow to set 5 minutes before

(-260C). If OEA lubricant is required to meet the

checking).

temperature ranges prescribed in the Key, OEA lubricant

is to be used in place of OE/HDO-10 lubricant for all

4. ENGINE. Oil is to be changed each 100 hours.

temperature ranges where OE/HDO-10 is specified. in

Drain when lubricant is warm.

the Key.

TA221804

CARD 6 OF 7